Aeotec - Z-Wave+ 700 Water Sensor 7

Presentation

The Water Sensor 7 is a sensor designed to detect drops and leaks and help mitigate water damage through the use of wireless coupled technologies such as water cut-off valves.

Powered by battery and built on Gen7 and 700 Z-Wave technologies, the Water Sensor 7 was designed as a product that is installed and forgotten with up to 3 years of autonomy.

Leak detection

Leaks are a building block of expensive bills and costly damage when they appear where they shouldn't. Monitoring more than just the presence of liquid, the Aeotec Water Sensor 7 lives up to its name by monitoring for the absence of water. When used to monitor tanks or pits, the Aeotec 7 water sensor can alert you when water levels get too low and trigger automation routines.

Leak protection

He doesn't just monitor when the water is going badly. Once connected to a Z-Wave automation system, the Water Sensor 7 can take protective measures to help limit the amount of damage caused by drops, leaks, chips or any other flow of water.

Quality Foundation

The accuracy, reliability and compatibility of the Water Sensor 7 start at its core. With its leakage processor of only 70x30 mm, it was built on Aeotec's exclusive Gen7 technology, which allows it to be installed wirelessly almost anywhere in a room and run for 3 years before its only 3.6-volt battery needs to be changed.

Duties

• High-precision 0.5mm leak detection via a detection probe
• Ultra-compact form factor
• Detection probe for leak detection in hard-to-reach areas
• Designed with Gen7 technologies and the 700 Z-Wave series chip inside
• Gen7 enables compatibility with Security 2 and SmartStart

Technical characteristics

• Power Supply: 1/2 AA ER14250 3.6V battery
• Battery life: up to 3 years
• Radio frequency: 868.42MHz
• Operating distance: up to 150 meters outside, 50 meters inside
• Operating humidity: 10 to 95%
• Operating Temperature: 0°C to 45°C
• Cable length: 1.5 m
• Dimensions: 70x13x20mm
• Weight: 42 g