Refurbished- Thermofloor - Thermostat Z-Wave Heatit 3600W 16A, white

Controlled return

PRESENTATION

The Z-Wave Heatit thermostat is a wall thermostat that allows you to control your electric heating, underfloor heating, etc.

The Heatit thermostat is equipped with a Z-Wave chip that allows it to be connected to home automation systems (FIBARO, eedomus, Vera, Zipato, etc.

It has a very clear display that indicates the set temperature. The screen allows you to navigate through the menus to configure the many options available through three touch buttons.

This thermostat plugs wired into the existing heater to switch the heating to ON/OFF. The set temperature can be changed directly via the screen or through a compatible home automation controller.

To measure temperature, the thermostat has an integrated probe, but also offers connectors to connect a ground temperature probe or an external temperature probe.

It is possible to memorize two different instructions thanks to the Comfort and Eco modes:

• Comfort: Is used for normal use. Example: 22 ° C.
• Eco: Is a withdrawal mode that you can use if the thermostat is installed in a room or house that is rarely used. ECO mode can also be activated by the pilot wire if it is connected. Example: 15 ° C.

DUTIES

• Z-Wave thermostat for electric heating, underfloor heating, etc.
• Possibility to set the temperature up to + or - 4 ° C in case of bias.
• Hysteresis regage
• Backlit display with brightness adjustment
• Possibility to completely turn off the display in standby mode (use in a room for example)
• Parental lock
• Ambient probe
• External temperature sensor provided (3m)
• Temperature limiter
• Power Regulator
• Z-Wave 500 series chip
• Weekly program / withdrawal temperature via a home automation box
• ECO Modes / Comfort
• Can be used with different NTC sensors
• 8 scenarios

TECHNICAL CHARACTERISTICS

• Display: LED screen 3x 7-Seg 13.2mm white
• Power Supply: 230V - 50/60 Hz
• Maximum load: 16A (resistive)
• Temperature Range: +5°C / +40°C
• Displayed temperature: -30°C .... 60 °C
• Temperature limit: 5 °C ... 35 °C
• Minimum Regulator Limit: 0 (0 ... 9)
• Co mode setpoint: 21°C (5°C... 40 °C)
• ECO mode setpoint: 18°C (5°C... 40 ° C)
• Power Regulator: P02 (P00 ... P10) 30-minute cycle
• Activation Removal Temperature: Z-Wave User Interface / Driver Wire
• IP Class: IP21
• Color: White RAL 9003
• Certifications: CE - FIMKO - Z-Wave Plus